Page 40
10 CHANGING PARAMETERS USING THE SMS
COMMAND
All programming parameters for GSW2 PLUS can also be sent by SMS command. Each SMS
command should start and stop with semicolon. If the confirmation SMS is needed, put “+” at the
beginning of the command SMS.
The first SMS is SMS with telephone numbers (TN1 – TN5). If you would like to check which
telephone numbers are programmed in GSW2 PLUS please use the following command:
;PTN;
Return SMS is (example):
;TN1=0;TN2=0;
If you would like to enter telephone numbers in to GSW2 PLUS you can use the following
example:
;TN1=040713470;TN2=+38643364850;
If you would like to receive confirmation SMS write “+” before SMS command:
;+TN1=040713470;TN2=+38643364850;
Return SMS from GSW2 PLUS is:
;TN1=040713470;TN2=+38643364850;
You can use the same programming procedure for all parameters.
It is also possible to change different parameters with one SMS. Consider that the SMS message
should not be longer than 160 characters (included space characters).
If you would like to change the following parameters TN1, IN1, IN2, OS1, OS2; ID1, LN1 and
CRE and would like to receive confirmation SMS, try next example:
;+TN1=+38640713470;IN1=1;IN2=1;OS1=15;OS2=1;ID1=120;LN1=1;
Send SMS message to GSW2 PLUS telephone number and in a few seconds you receive SMS
message from GSW2 PLUS. The sentence of the SMS must be the same as the one you have sent to
GSW2 PLUS before.
To Next Page
