MARS COMMERCE GSW2 PLUS 1000 - Receive Credit Pars Parameters (Pcref); Receive Credit Check Telephone Numbers (Pcn); Receive All Clip Parameters (Pclp); Receive Pin Access Codes (Ppin)

GSW2 PLUS EXT
INSTALLATION MANUAL
Page 38
9.16 RECEIVE CREDIT PARS PARAMETERS (PCREF)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed credit parse parameters (CREF, CVODA…):
;PCREF;
9.17 RECEIVE CREDIT CHECK TELEPHONE NUMBERS (PCN)
By sending this command to GSW2 PLUS you receive SMS message with programmed numbers
for credit checking (CC1, CC2…):
;PCN;
9.18 RECEIVE ALL CLIP PARAMETERS (PCLP)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed CLIP functionality related parameters (CLPEN, CLPOU, CLPI, CLPx):
;PCPL;
NOTE
User can use ;PCPL=x,y; to limit the number of CLIP numbers to be printed.
x = start number
y = end number
Example
;PCLP=1, 30; Prints first 30 CLIP numbers
9.19 RECEIVE PIN ACCESS CODES (PPIN)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed PIN access codes (PIN1, PIN2, …, PIN999, PIN1000).
;PPIN;
NOTE
User can use ;PPIN=x,y; to limit the number of PIN numbers to be printed.
x = start number
y = end number
Example
;PPIN=1,30; Prints first 30 PIN numbers
9.20 RECEIVE SPIN ACCESS CODES PARAMETERS (PSPIN)
By sending this command to the device you receive SMS message with all currently programmed
SPIN parameters:
;PSPIN;
NOTE
User can use ;PSPIN=x,y; to limit the number of SPIN numbers to be printed.
x = start number
y = end number
Example
;PSPIN=1,5; Prints first 5 SPIN numbers