Page 39
9.21 RECEIVE INTERCOM BUTTON 1 PARAMATERS (PDEA)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed button 1 group parameters (ATN1, ATN2, ATN3, ATN4, ATN5, RTNA, SDNA,
SDDA, TZSA, TZEA):
;PDEA;
9.22 RECEIVE INTERCOM BUTTON 2 PARAMATERS (PDEB)
By sending this command to GSW2 PLUS you receive SMS message with all currently
programmed button 2 group parameters ( BTN1, BTN2, BTN3, BTN4, BTN5, RTNB, SDNB,
SDDB, TZSB, TZEB ):
;PDEB;
9.23 STATE OF THE CREDIT FOR THE PREPAID CARD
By sending this command to GSW2 PLUS you receive SMS message with Credit amount on your
prepaid SIM card:
;PCCX;
Where X is the number of programmed prepaid card provider.
9.24 STATE OF THE OUTPUTS (PORC)
By sending this command to GSW2 PLUS you receive SMS message with current outputs state.
;PORC;
9.25 MANUAL GSM MODULE RETARD (MRES)
By sending this command to GSW2 PLUS shuts down GSM module and after a few second it
switches the power of the GSM module ON again. The unit reboots all parameters from the SIM
card.
;MRES;
9.26 RECEIVE STATUS OF INPUTS (INS)
By sending this command to GSW2 PLUS you receive SMS message with current input state.
;INS;
9.27 RECEIVE GSW2 PLUS LOG
By sending this command to GSW2 PLUS you receive SMS message with log on GSW2 PLUS
device.
;PLOG;
9.28 RECEIVE WIEGAND PARAMETERS
By sending this command to GSW2 PLUS you receive SMS message with parameters used to
configure Wiegand interface:
;PWG;
To Next Page
