MARS COMMERCE ZEUS4 - Table 22: ZEUS4-VD DTMF Commands

ZEUS4-VD
INSTALLATION MANUAL
22
11.2.11 DTMF REMOTE COMMANDS
When ZEUS4-VD enters VOICE call user has the option to control device via DTMF command. By
default this DTMF control is limited to canceling the ongoing and all next call.
The user receives a confirmation of most DTMF commands via DTMF feedback pattern 1 or 3
beeps.
REMOTE COMMAND
ACTION DESCRIPTION
00
All outputs OFF (3 beeps=OFF)
01
All outputs ON (1 beep=ON)
10
Output 1 OFF (3 beeps=OFF)
11
Output 1 ON (1 beep=ON)
12
Check the output 1 state (1 beep=ON, 3 beeps=OFF)
20
Output 2 OFF (3 beeps=OFF)
21
Output 2 ON (1 beep=ON)
22
Check the output 2 state (1 beep=ON, 3 beeps=OFF)
30
Output 3 OFF (3 beeps=OFF)
31
Output 3 ON (1 beep=ON)
32
Check the output3 state (1 beep=ON, 3 beeps=OFF)
40
Output 4 OFF(3 beeps=OFF)
41
Output 4 ON (1 beep=ON)
42
Check the output4 state (1 beep=ON, 3 beeps=OFF)
51
Input 1 status checking (1 beep=alarm, 3 beeps=normal)
52
Input 2 status checking (1 beep=alarm, 3 beeps=normal)
53
Input 3 status checking (1 beep=alarm, 3 beeps=normal)
54
Input 4 status checking (1 beep=alarm, 3 beeps=normal)
99
Listen-in ON
90
Listen-in OFF
*
Does not call this telephone number again
#
Complete interruption of the dialing procedure
Table 22: ZEUS4-VD DTMF commands