MARS COMMERCE ZEUS4 - 17 Changing Parameters Using the Sms Command

ZEUS4-VD
INSTALLATION MANUAL
42
17 CHANGING PARAMETERS USING THE SMS
COMMAND
All programming parameters for ZEUS4-VD can also be sent by SMS command. Each SMS
command should start and stop with semicolon. If the confirmation SMS is needed, put “+” at the
beginning of the command SMS.
The first SMS is SMS with telephone numbers (TN1 – TN0). If you would like to check which
telephone numbers are programmed in ZEUS4-VD please use the following command:
;PTN;
Return SMS is (example):
;TN0=0;TN1=0;TN2=0;TN3=0;TN4=0;TN5=0;TN6=0;TN7=0;TN 8=0;TN9=0;
If you would like to enter telephone numbers in to ZEUS4-VD you can use the following example:
;TN0=040713470;TN1=+38643364850;TN2=041255630;TN3=0;TN4=0;TN5=0;TN6=0;T
N7=0;TN8=0;TN9=0;
If you would like to receive confirmation SMS write “+” before SMS command:
;+TN0=040713470;TN1=+38643364850;TN2=041255630;TN3=0;TN4=0;TN5=0;TN6=0;T
N7=0;TN8=0;TN9=0;
Return SMS from ZEUS4-VD is:
;TN0=040713470;TN1=+38643364850;TN2=041255630;TN3=0;TN4=0;TN5=0;TN6=0;T
N7=0;TN 8=0;TN9=0;
NOTE
You can use the same programming procedure for all parameters.
NOTE
It is also possible to change different parameters with one SMS. Consider that the SMS
message should not be longer than 160 characters (included space characters).
If you would like to change the following parameters TN1, IN1, IN2, OS3, OS4; ID1, LN1 and
CRE and would like to receive confirmation SMS, try next example:
;+TN1=+38640713470;IN1=1;IN2=1;OS3=15;ID1=120;LN1=1;CRE=4;
Send SMS message to ZEUS4-VD telephone number and in a few seconds you receive SMS
message from ZEUS4-VD. The sentence of the SMS must be the same as the one you have sent to
ZEUS4-VD before.