MARS COMMERCE ZEUS4 - Receive the Power Level on the Unit (Ppwr); Receive Set-Up Parameters Value (Ppa); State of the Credit for the Prepaid Card; Receive CID Parameters (Pcid)

ZEUS4-VD
INSTALLATION MANUAL
37
12.18 RECEIVE THE POWER LEVEL ON THE UNIT (PPWR)
By sending this command to ZEUS4-VD you receive SMS message with current main power level
in volts or current battery voltage when the unit runs on the backup battery. Send: ;PPWR;
12.19 RECEIVE SET-UP PARAMETERS VALUE (PPA)
By sending this command to ZEUS4-VD you receive SMS message with all currently programmed
Setup parameters (CRE, MNF, MAIN…). Send: ;PPA;
12.20 STATE OF THE CREDIT FOR THE PREPAID CARD
By sending this command to ZEUS4-VD you receive SMS message with Credit amount on your
prepaid SIM card. Send: ;PCCX; Where X is the number of programmed prepaid card provider.
12.21 RECEIVE CID PARAMETERS (PCID)
By sending this command to ZEUS4-VD you receive SMS message with CID configuration.
Send:v;PCID;
12.22 RECEIVE SIMPLE CLIP PARAMETERS (PCLP)
By sending this command to ZEUS4-VD you receive SMS message with simple CLIP
configuration. Send: ;PCLP;
12.23 RECEIVE LOG PARAMETERS AND EVENTS (PLOG)
By sending this command to ZEUS4-VD you receive SMS messages with log parameters and log
events. Send: ;PLOG;
NOTE
When working with SMS use this parameter print with care. It might generate lot of
SMS messages in replay.
12.24 STATE OF THE OUTPUTS (PORC)
By sending this command to ZEUS4-VD you receive SMS message with current outputs state.
Send: ;PORC;
12.25 STATE OF THE INPUTS (INS)
By sending this command to ZEUS4-VD you receive SMS message with current input state.
Send: ;INS;
12.26 RECEIVE SYSTEM STATUS (PSYS)
By sending this command to ZEUS4-VD you receive SMS message system current time and up
time. Send: ;PSYS;