MARS COMMERCE ZEUS4 - 16 Checking and Changing Output Status; Checking Output Status by Sms Command; Orc Parameter; Output Remote Control by Sms Command

ZEUS4-VD
INSTALLATION MANUAL
41
16 CHECKING AND CHANGING OUTPUT STATUS
User can manage outputs with the use of SMS command.
16.1 CHECKING OUTPUT STATUS BY SMS COMMAND
By sending this command to ZEUS4-VD you receive SMS message with all Output status:
;PORC;
Return SMS message is:
 ;Output 1=(ON-OFF) – status on output 1.
 ;Output 2=(ON-OFF) – status on output 2.
 ;Output 3=(ON-OFF) – status on output 3.
 ;Output 4=(ON-OFF) – status on output 4.
16.2 ORC PARAMETER
This parameter is used to control outputs directly via SMS message.
16.3 OUTPUT REMOTE CONTROL BY SMS COMMAND
By sending this command to ZEUS4-VD the output X is switched ON:
;ORCX=1; For X please choose one of the output numbers from 1 to 4.
By sending this command to ZEUS4-VD the output X is switched OFF:
;ORCX=0; For X please choose one of the output numbers from 1 to 4.
If you would like to receive SMS message with the Output status write “+” before SMS command:
;+ORCX=1; For X please choose one of the output numbers from 1 to 4.
Return SMS message is:
ORCX=(ON) Where X is one of the output numbers from 1 to 4.
Table of parameters:
Name
Comment
ORC1
Control of output 1
ORC2
Control of output 2
ORC3
Control of output 3
ORC4
Control of output 4
Table 35: ORC parameters
Example:
 Remote programming by SMS
SMS commad
Description
;ORC1=1;
Activate output 1
;ORC2=0;
Deactivate output 2
Table 36: ORC parameters example