4
114
Instruments and Controls
In case of contemporary failure events,
high priority messages have priority of
visualization, then follows the failures
with low priority.
The visualization time can be interrupted
in two ways:
• disappearance of the malfunction that
provokes warning visualization;
• short pressure of the MENU button on
the left multifunction lever behind the
steering wheel. In this case the screen
before the failure event shall be shown
again, but the relative warning light (if
present) shall remain active until the
malfunction is solved.
If, during visualization of a high priority
failure message, a low priority failure
occurs, it will wait until the visualization
cycle is completed and then is displayed
on the screen. Subsequent visualization
logic shall remain “rolling”.
Information and Feedback Messages
The management of the visualization of
the information and feedback messages
on the screen is similar to the one
described for the warning messages.
The only exception for information
messages is the absence of acoustic
signaling that accompanies the message
(except for some cases, example: door
open with car moving).
The feedback messages, that generally
indicate the activation/deactivation of a
specific function upon driver’s request,
remain valid the same considerations
described for the visualization of the
information messages.
The prescriptions regarding visualization
logic of feedback messages are the
same as for the low priority failure
messages.
Rolling Mode Visualization
“Rolling” mode is a method of
visualization where the screens are
alternated depending on the priority or
appearance order of the relative events.
“Rolling” mode is based on cycle of
visualizations. The total number of cycles
is able to cover the total respective
times of visualization.
In case of interruption, due to new
events, the visualization is anyway
displayed once events that caused the
interruption are terminated.
Trip Display
“Trip” is the default content displayed on
the left side contents area (see “Controls
to Set and Configure the Instrument
Cluster” in this section).
The trip area displays the following
parameters:
1. Total odometer
2. Distance (*)
3. Elapsed time (*)
4.
Average consumption (*)
5. Average speed (*).
(*) These values can be reset with a long
press of the MENU button on the left
multifunction lever.
• The “Elapsed time” 3 is shown in
hhh:mm format. The maximum counter
is 999:59. After that, the counter will
restart from 00:00.
• After a reset, or if the signal is not
available, the value of the related items
is replaced with a dash (“-“) for each
digit, except for the elapsed time that
will restart from 00:00.
Pedals and Gauges Display
“Pedals” is the default content displayed
on the right side contents area (see
“Controls to Set and Configure the
Instrument Cluster” in this section).
Brake Accelerator Pedals
For brake (BRAKE) and accelerator
(GAS) pedals the instrument cluster
displays the graphic dynamic bars in the
To Next Page
Loading...
