b) Remove the earth wire and the connector,
connect these to the new printhead and make a note of the
Print Head Serial No.
Click ‘Next’ to continue.
5. Insert the new print head.
During re-insertion, press with the sphere present in the tip of the
printhead on the point indicated in the figure and rotate to insert it
in its housing, close the top cover once complete and Click ‘Next’
to continue.
3) C
o
nne
c
t
the
pr
inter
to
the
pow
e
r su
pply
and switch the printer on, then click ‘Next’ to continue.
To Next Page
Loading...
