Matrix Vision User Manual

Matrix
208
Vision System Manual
Step 5
Use following command to playback the recorded VM partition:
1406-Part Number
Where,
Part Number is from 00 to 15.
Step 6
Use following command to assign an application to a VM partition:
1407-Voice Message Application-Part Number
Where,
Part Number is from 00 to 15.
Voice Message Application Meaning
00 Day Greeting
01 Night Greeting
02 Initial Guidance Message
03 Dial by Name Message
04 No Dial Message
05 Wrong Dial Message
06 Transfer Message
07 Busy Message
08 No Reply Message
09 Music on Hold
10 Alarm
11 Emergency Message
12 Auto Redial
Use following command to de-assign application from a VM partition:
1407-Voice Message Application-#
Step 7
Use following command to set default values for all the VM parameters:
1401-#
On issuing this command VM config is changed as follows:
1. VM duration = 240 seconds.
2. Number of VM parts = 13.
3. Recording source = Telephone.
4. Assignment of Voice Message Application to part number = As shown to the table.
How to record/verify a voice message?
Recording from a telephone:
This method is very simple. Whatever we speak on the phone is recorded. It is done as follows:
• Select a good quality extension with good telephone.
• Request a person with clear voice to record the message in his or her voice.
• Select a peaceful place. Switch OFF fans and other sources of noise.
• Avoid room noise to maintain clarity of the message.
• Enter in the programming mode from this extension.
• Issue command 1404-0.
• You will get confirmation tone.
• Issue command 1405-Part Number.
• Start recording your message.

Matrix Vision Specifications

General

Brand	Matrix
Model	Vision
Category	PBX
Language	English