Maxon Datamax 4G User Manual

Indicator Lights Introduction
The router provides following indicator lights: “Power”, “System”, “Online”, “GPS”,
“Local Network”, “WAN”, “WIFI”, “Signal Strength”.
The table below shows the details of the LED functions:
Indicator Light
State
Introduction
Power
ON
Router is powered on
OFF
Router is powered off
System
BLINK
Router is up and working
OFF
Router is not currently working
Online
ON
Router has logged on network
OFF
Router hasn’t logged on network
GPS
ON
GPS is active
OFF
GPS is not active
Local Network
OFF
The corresponding interface of switch is not
connected
ON /
BLINK
The corresponding interface of switch is connected
/Communicating
WAN
OFF
The WAN interface is unplugged
ON /
BLINK
The WAN interface is plugged in/data is traversing
the WAN interface
WIFI
OFF
WIFI is not active
ON
WIFI is active
Signal Strength
One Light
ON
Signal strength is weak
Two
Lights ON
Signal strength is medium
Three
Lights ON
Signal strength is good
Reset Button
The modems “Reset” button is used to restore the modem to its original factory
default settings. To restore the router to factory default settings, the user needs to
press the “Reset” button and hold it in for 15s, the router will then restore its original
factory default settings and restart automatically. Note that the reset button is
recessed to prevent accidental resets – to press, use a small tool such as a
ballpoint pen.

Maxon Datamax 4G Specifications

General

Brand	Maxon
Model	Datamax 4G
Category	Network Router
Language	English