RF Exposure Compliance
The use of this device in any other type of host configuration may not
comply with the RF exposure requirements and should be avoided. During
operation, a 20-cm separation distance should be maintained between
the antenna, whether extended or retracted, and the user’s/bystander’s
body (excluding hands, wrists, feet, and ankles) to ensure RF exposure
compliance.
Caution
Change or modification without the express consent of RF Industries voids
the user’s authority to use the equipment. These limits are designed to
provide reasonable protection against harmful interference in an
appropriate installation. The modem is a transmitting device with similar
output power to a mobile phone. This equipment generates, uses, and can
radiate radio frequency energy and, if not used in accordance with
instructions, can cause harmful radiation to radio communication.
Unauthorized antennas, modifications, or attachments could impair call
quality, damage the device, or result in violation of RF exposure
regulations.
However, there is no guarantee that interference will not occur in a
installation. If the equipment does cause harmful interference in radio and
television reception, which can be determined by turning the equipment
on and off, the user is encouraged to try to correct the interference by one
or more of the following measures:
▪ Re-orient or relocate the receiving radio or TV antenna
▪ Increase the separation distance between the equipment and
the receiver
▪ Contact Maxon Australia Technical Support for assistance.
Notes The user is cautioned that changes or modifications not expressly
approved by Maxon Australia could void the warrantee.
To Next Page
Loading...
Need help?
General
