11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
14
VEHICLE REQUIREMENTS FOR TRAILERS
Check for correct clearances (FIGS. 14-1 and 15-1, refer to TABLE 15-1), on vehicle
to prevent interference between vehicle and Liftgate.
NOTE: Make sure vehicle is parked on level ground with parking brake set while
preparing vehicle and installing Liftgate.
NOTE: Maximum operating bed height for trailer is is 60” (Unloaded).
Minimum bed height is 46” (Loaded).
On vehicle bodies equipped with swing-open doors, the platform
may have to be modifi ed to install this Liftgate.
NOTE: Dimensions are provided as reference for fi tting Liftgate to vehicle body.
For detailed ground clearance information, refer to the BOLT ON INSTAL-
LATION PLATE procedure in this manual.
CAUTION
The sliding axle assembly on a trailer can collide with a Liftgate mounted
on the slide rails. To prevent damage to Liftgate and trailer, install stops on
the slide rails to keep the sliding axles from hitting Liftgate. Refer to Liftgate
clearance dimensions in this section of the manual.
OVERALL WIDTH OF LIFTGATE & MOUNTING FRAME
FIG. 14-1
SW
PW
W
FW
RS
REAR SILL
To Next Page
Loading...
