11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
50
STEP 4 - RUN POWER CABLE
1. Liftgate powered by tractor batteries is
typically installed on trailers as shown
in FIG. 50-1.
NOTE: Make sure the Liftgate power unit, and all batteries on the vehicle for the
power unit, are connected correctly to the J-box.
RECOMMENDED CONFIGURATION
LIFTGATE
RECOMMENDED LIFTGATE & OPTIONAL BATTERY BOX
INSTALLATION ON TRAILER
FIG. 50-1
175 AMP
FUSED CABLE
TRACTOR BATTERIES,
TYPICAL LOCATION
LIFTGATE
J-BOX
175 AMP
FUSED CABLE
Never route an energized wire. Make sure the vehicle battery is disconnected.
Always route electrical wires clear of moving parts, brake lines, sharp edges
and exhaust systems. Avoid making sharp bends in wiring. Attach securely.
If drilling is necessary, fi rst check behind the drilling surface so you do not
damage any fuel lines, vent lines, brake lines or wires.
CAUTION
!
OPTIONAL BATTERY
BOX
2. Position fuse-end of red (+) cable with fuse nearest
the tractor batteries, as shown in FIG. 50-1. Run black
(-) cable from tractor batteries, as shown in FIG. 50-1.
Keep enough cable near batteries to reach the power
(+) and ground (-) terminals without straining cables
(after connection). Connect cables to optional battery
box (trailer) and J-box. Secure power cable to vehicle
chassis.
To Next Page
Loading...
