Maxon GPSLR Series - Page 58

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
58
4. Lower platform to ground level (FIG. 58-2). Ensure
platform tip and shackle touch ground at the same
time (FIG. 58-2). If platform tip or shackle don’t
touch ground, loosen the adjuster bolt lock nuts on
both sides of the unit (FIG. 58-2A). Turn the adjust-
er bolts clockwise to tilt platform down and couter-
clockwise to tilt platform up (FIG. 58-2A). Tighten
locking nuts to 80-120 lb-ft.
3. Unfold fl ipover (FIG. 58-1).
UNFOLD FLIPOVER
FIG. 58-1
FLIPOVER
PLATFORM LOWERED TO GROUND
FIG. 58-2
PLATFORM
TIP
SHACKLE
FIG. 58-3A
ADJUSTER BOLT
(2 PLACES)
LOCK NUT
(2 PLACES)
STEP 7 - PLATFORM ADJUSTMENT- Continued
DRAFT 05-03-24