11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
27
STEP 2 - WELD LIFTGATE TO VEHICLE - Continued
Painted Liftgate is shipped from factory with mounting plates temporarily bolt-
ed to main frame. Before operating Liftgate unbolt, position, & weld mounting
plates to main frame as shown in illustrations below.
WARNING
!
NOTE: If main frame is galvanized, skip instructions 4 and 5. Go to instruction 6.
NOTE: On some low bed trucks, wood spacer may interfere with having two 7”
vertical welds per mounting plate. If the spacer interferes with minimum 7”
welds, cut and weld the top of each mounting plate 1/2” below the top radius
of the truck frame.
WARNING
Prevent damage to hydraulic hoses. If welding next to hydraulic hoses, use a
protective cover such as a welding blanket to cover the hoses.
CAUTION
To protect the original paint system, if equipped, a 3” wide area of paint must
be removed from all sides of the weld area before welding.
CAUTION
CAUTION
When using an electric welder, connect the welder ground to one of the parts
being welded, as close to the weld as possible. Failure to comply could result
in damage to cylinders and electrical parts.
To Next Page
Loading...
