Driveline/Axle
Propeller Shaft
• The propeller shaft transmits drive force from the transfer case to the rear differential.
• The propeller shaft is made of steel and is 60.5 mm in diameter. It comprises one
constant velocity (tripod double offset) joint and three cross-shaped joints.
M6-MPS_03001
Rear Axle Cross-Sectional View
• The rear axle uses cartridge-type angular ball bearings, that allow the installation of drive
shafts for the rear wheels.
M6-MPS_03002
1 Angular ball bearing
03-10 Service Training Mazda6 MPS Supplement
To Next Page
Loading...
