To Next PageTo Next Page
Need help?Do you have a question about the MC Technologies MC100 and is the answer not in the manual?
General| Protocols | MQTT |
|---|---|
| Cellular | 4G LTE, 3G, 2G |
| Ethernet | 1 x 10/100 Mbps RJ45 |
| Serial | RS232/RS485 |
| Digital Outputs | 2 relay outputs |
| Digital Inputs | 2x optically isolated digital inputs |
Manufacturer's warranty terms and conditions for product use.
Specifies crucial operational parameters and limits for product safety.
Operator responsibilities for adhering to national regulations and safe operation.
Requirements for personnel performing installation, commissioning, and maintenance.
Instructions for safe handling, packing, and checking the product during transport and storage.
Explanation of product markings and disposal guidelines according to environmental regulations.
Information about third-party open-source software included in the product.
Manufacturer's liability regarding the use of open-source software.
How to find a list of open-source software used in the product.
Description of the different MC100 terminal/gateway variants available.
Instructions for mounting the antenna and checking network coverage.
Step-by-step guide for inserting the SIM card into the device.
Connecting the external DC power supply and understanding the power LED status.
Accessing and logging into the device's web interface for initial setup.
Configuring APN, PIN, and establishing a mobile network connection.
Performing online tests and checking the modem firmware version for connectivity.
Connecting via Internet, SSH, command line, and changing the device IP address.
Guidelines for installing the MC100 in a vehicle, requiring specific E1 marking.
Enabling the Node-RED application within the MC100's system startup.
Guide for installing additional modules via the Node-RED palette manager.
Adding nodes to the workspace and connecting them using wires.
Adding a debug node and deploying the created Node-RED flow.
Reading analog and digital IOs from MC100 GPIO via Node-RED.
Creating a dashboard to visualize data using Node-RED dashboard nodes.
Reading analog inputs, writing analog outputs, and PT100/1000 inputs for SensT2.
Overview of the MC100 circuit, Ethernet, Power, RS485, CAN, RS232, and USB interfaces.
Controlling MC100 Gateway digital inputs and outputs via command line.
Managing MC100 GPIO digital inputs, outputs, voltage, current, and PWM via command line.
Managing MC100 SensT2 digital, voltage, current, and PT100/PT1000 IOs via command line.
Managing MC100 SensorBox digital, current, PT100/PT1000 IOs, and relays via command line.
Explanation of the device's LED indicators and their configuration options.
Configuring the MC100 to act as a Wi-Fi access point.
Configuring the MC100 to connect to an existing Wi-Fi network as a client.
Steps for configuring the MC100 as an OpenVPN client.
Steps for configuring the MC100 as an OpenVPN server.
Configuring general firewall settings like SYN-flood protection and packet filtering.
Setting up port forwarding rules to allow external access to internal services.
Defining traffic rules and custom firewall rules for network security.
Setting up and using the mcwmbus tool for WM-Bus communication via LuCI and CLI.
Handling WMBus data output formats, writing to disk, and sending to REST APIs.
Viewing live WMBus data in Node-RED and obtaining support.
Integrating MODBUS with Node-RED for data acquisition and control.
Using the Modbus Master command-line tool for device interaction.
Using Modbus Slave CLI and understanding JSON mapping for device emulation.
Setting up the MBUS module and using the libmbus library for communication.
Configuring and using OWServer, OWFS, and OWhttpd for 1-Wire devices.
Information on the product's maintenance-free nature.
How to get assistance for product faults from MC Technologies support.
Procedures for sending defective products for repair, including RMA and backup steps.
Instructions for the return and recycling of old MC Technologies equipment.
