1 General
These instructions enable the safe and efficient handling of the product. The instructions
are an integral part of the product and must be kept accessible at all times to installation,
commissioning and operating personnel.
Warranty provisions
Unauthorized use, non-observance of this documentation, the use of insufficiently
qualified personnel and unauthorized modifications exclude the manufacturer's liability for
resulting damages. The manufacturer's warranty is void. The provisions of our terms and
conditions of delivery and purchase (AGB) apply. These can be found on our website
(https://www.mc-technologies.net/en/terms-and-conditions.php)
2 Safety
The Safety section provides an overview of the safety instructions to be observed when
operating the product.
The product has been constructed in compliance with the currently valid rules of
technology and is safe to operate. It has been tested and has left the factory in perfect
condition in terms of safety. In order to maintain this condition over the operating time,
the information in the applicable publications and certificates must be observed and
followed.
The basic safety instructions must be strictly maintained when operating the product. In
addition to the basic safety instructions, the individual sections of the documentation
contain descriptions of procedures and operating instructions with specific safety
information.
Furthermore, the local guidelines for the prevention of accidents and general safety
regulations for the area of application of the device should be applied.
Only the consideration of all safety instructions enables the optimum protection of
personnel and the environment against hazards as well as the safe and trouble-free
operation of the product.
Technical limiting values
The product is exclusively intended for use within the technical limits specified in the data
sheets.
The following limit values must be observed:
• The surrounding temperature limits must not be exceeded or dropped below.
• The supply voltage range must not be violated under or above.
• The maximum air humidity must not be exceeded and condensation must be
avoided.
• The maximum switching voltage and the maximum switching current load must not
be exceeded.
• The maximum input voltage and the maximum input current must not be
exceeded.
To Next Page
Loading...