MC Technologies MC100 - Operator Obligations; Personnel Qualification; Transport and Storage Guidelines; Product Labels and Environmental Protection

MC100
Mobile programmable gateway
MC Technologies GmbH, Kabelkamp 2, 30179 Hannover, Germany
Tel: +49511 67 69 99-0, Fax: +49511 67 69 99-150, Website & Shop: www.mc-technologies.net, Email: info@mc-technologies.net
6
Obligations of the operator
The operator must always observe the national regulations applicable in his country
regarding the operation, functional testing, repair and maintenance of electronic devices.
Qualification of personnel
Installation, commissioning and maintenance of the product may only be carried out by
trained specialist personnel authorised by the system operator. The qualified personnel
must have read and understood this documentation and follow the instructions.
The electrical installation and commissioning of the product may only be carried out by a
person who, due to his or her specialist training, knowledge and experience as well as
knowledge of the relevant standards and regulations, is able to carry out work on electrical
systems and independently detect and avoid possible hazards.
Guidelines for transport and storage
The following instructions must be observed:
• Do not expose the product to moisture or other potentially harmful environmental
conditions (radiation, gases, etc.) during transport and storage. Pack the product
properly.
• Pack the product so that it is protected from shocks during transport and storage,
e.g. by using air-cushioned packaging.
• Before installing the product, check it for possible damage that may have been
caused by improper transport or storage. Damage in transit must be noted on the
shipping documents. All claims for damages must be made immediately and before
installation to the carrier / company responsible for storage.
Labels on the product
The type plate of the product is located as a sticker on one surface of the product. It may
contain the following markings, among others, which are explained in more detail here.
Dispose of old equipment in an environmentally responsible
manner
This symbol indicates that old devices must be disposed of separately
from residual waste at suitable collection points. See also the
disposal section in this manual.
CE-label
By affixing the CE marking, the manufacturer confirms that the
product complies with the product-specific applicable European
regulations.
Environmental protection
Dispose the product and its packaging in accordance with the relevant environmental protection
regulations. Refer to the disposal section of this manual for instructions on how to dispose of the
product. Separate the packaging components made of cardboard and paper as well as plastic
and recycle them using the appropriate collection systems.