MC Technologies GmbH, Kabelkamp 2, 30179 Hannover, Germany
Tel: +49511 67 69 99-0, Fax: +49511 67 69 99-150, Website & Shop: www.mc-technologies.net, Email: info@mc-technologies.net
71
20 Factory reset
WARNING:
All customized setting will be reset to factory. Make sure you are directly
connected to the MC100.
To reset the MC100:
• Locate the Reset button on the back of your MC100 device.
• Use the pointed end of a paperclip or similar object to press and hold the Reset
button.
• Then while still holding the button, connect the power, the green LED (info) will
light up.
• After approximately 5 seconds the green LED (info) will start flashing for approx.
1second.
• When the green LED (info) stops flashing you can release the button.
• After 10 seconds, the green LED 5 will start flashing indicating that the reset
process is running.
• Wait for the green LED (status) to stop flashing. That means the device is fully reset
and is ready to be used.
The default factory settings have been restored.
To Next Page
Loading...
