MC Technologies MC100 - Internet Access and SSH

MC100
Mobile programmable gateway
MC Technologies GmbH, Kabelkamp 2, 30179 Hannover, Germany
Tel: +49511 67 69 99-0, Fax: +49511 67 69 99-150, Website & Shop: www.mc-technologies.net, Email: info@mc-technologies.net
18
Internet access
After successfully logging into the mobile network, you can now connect to the Internet
using your browser. To do this, open the browser on your PC and enter a URL known to you
in the address field (e.g. www.mc-technologies.net).
Access via SSH
To access the Linux system of the MC100, you must connect to the same IP address (default:
192.168.2.1) as the web interface with an SSH client. Most Linux distributions already have
an SSH client installed. On Windows PuTTY can be used.
The following access data are required:
User: root
Password: Please check the product label for the default password (or none if there is no
default password specified). If you’ve changed the password in LuCi, use this changed
password here.
To secure your MC100 change the password by entering "passwd" under SSH.
Command Line Interface
Open the Command Prompt to login your device:
1. Type: ssh root@192.168.2.1
2. Type the password.
Command
Use to
mcinfo info
Print general information about the modem.
mcinfo mobile
Print information about mobil communication status.
mcinfo gpio
Print information about external GPIO module pins.
Change IP-address
Using Command line
Open the Command Prompt to login your device:
1. Open the configuration file using command: nano /etc/config/network