Crush Points
Hydraulically operated jaws are operated under
pressure Anything caught in the jaws will be
crushed. Keep all body parts out of the jaw area.
Always check pipe alignment with a pencil or
similar object.
TX03091-4-7-10
Fusion Equipment Safety
WR00012-12-4-92
1 - 4
Electrical Safety
Always ensure power cords are properly
grounded. It is important to remember that you
are working in a wet environment with electrical
devices. Proper ground connections help to
minimize the chances of an electric shock.
Frequently inspect electrical cords and unit for damage. Have
damaged components replaced and service performed by a
qualified electrician.
Do not carry electrical devices by the cord.
NOTICE: Always connect units to the proper power source as listed
on the unit, or in the owner's manual. On units with two power
cords, plug each cord into separate power circuits. Do not plug
into both outlets of one duplex receptacle.
Disconnect the machine from the power source
before attempting to service the control panel.
Failure to disconnect the power could result
in electric shock. Refer service to a qualified
technician.
TX00105-5-6-13
WR00055-4-7-93
WR00025-11-30-92
Facer Blades Are Sharp
Facer blades are sharp and can cut. Never attempt
to remove shavings while the facer is running, or is
in the facing position between the jaws. Use care
when operating the facer, and when handling the
unit.
NOTICE: Disconnect power from the facer, and remove the facer
blades before attempting any maintenance or adjustment.
NOTICE: Never extend the blade beyond the inner or outer
circumference of the facer.
TX02378-1-24-05
WR00073-4-6-93
To Next Page
Loading...
