Fusion Machine Checklist
Item to Check Satisfactory Needs Repair Comments
Repair
UNIT
Machine is clean
All pins and snap rings are in place
All nuts and bolts are tight
All placards and handles are in place
All clamp knobs turn freely
Cords and plugs are in good condition
All hardware is on the basic machine
Hydraulic fluid reservoir is filled to correct level
Machine is free of hydraulic leaks
Hydraulic gauge reads correctly
Brake functions properly
Tire pressure is correct
Jaws are properly aligned
Facer pivot operates properly
Facer operates smoothly
Face-off is square
Inserts fit and pin properly
Primary pump pressure can be adjusted from
500 psi to 1200 psi
Input voltage to machine - (108 - 132 VAC)
Carriage and Selector Valves operate smoothly
Pressure Reducing Valves operate in their range
Filter gauge reads correctly
HEATER
Cord and plug are in good condition
Heater surface is clean and in good condition
Thermometer is in good working order
Surface temperature checked with pyrometer
Check receptacles for damage
Maintenance Checklist
8 - 1
TX02141-07-11-03
To Next Page
Loading...
