Fusion Equipment Safety
1 - 5
Fusion Procedures
Obtain a copy of the pipe manufacturer's procedures or
appropriate joining standard for the pipe being fused. Follow the
procedure carefully, and adhere to all specified parameters.
NOTICE: Failure to follow pipe manufacturer's procedure
could result in a bad joint. Always follow pipe
manufacturer's procedures.
TX04469-10-24-12
WR00079-1-24-96
Heater Is Hot
The heater is hot and will burn clothing and skin.
Keep the heater in its insulated heater shroud
when not in use, and use care when heating the
pipe.
NOTICE: Use only a clean non-synthetic cloth to clean the heater
plates.
TX04244-10-12-10
WR00030-2-10-93
Have Tires Properly Serviced
Failure to follow proper procedures when
mounting a tire on a wheel or rim can produce
an explosion which may result in serious injury
or death. Have tires mounted by someone that is
experienced, and has the proper equipment to
perform the job safety.
TX00118-4-22-93
WR00083-4-22-93
Do Not Tow Fusion Machine at Speeds Greater
than 5 MPH
The chassis is not designed for over-road towing.
Towing at speeds greater than five miles per hour
can result in machine damage as well as injury.
Always transport the machine by flatbed truck or
similar means, and make sure that unit is properly
secured.
TX00101-4-12-93
CD00189-1-24-96
To Next Page
Loading...
