11 - 2
250 Fusion Machine Dimensions:
Width: 38” (965mm)
Length: 65.5” (1664mm)
Height: 49.5” (1257mm)
Fusion Machine with Facer: 575 lbs. (261 Kg)
4-Jaw Carriage Assembly without Facer: 203 lbs. (92 Kg)
3-Jaw Carriage Assembly without Facer: 124 lbs. (56 Kg)
Facer: 44 lbs. (19.9 Kg)
Heater: 21 lbs (9.5 Kg)
Specifications:
The 250 model fuses 2” IPS (63mm) minimum to 250mm maximum pipe.
Design Pressure: 900 psi (62 BAR) max. (capable of more with modification)
Reservoir Capacity: 5 gallons (18.92 Liters)
Hydraulic Fluid: Refer to Hydraulic Fluids Section
Total effective piston area: 4.71 square inches (see cylinder label for other piston areas)
Heater Power: 3000 Watt
Sidewall Heater Power: 1750 Watt
Available in butt fusion or a combination of butt and saddle fusion configuration
Designed for connecting the McElroy Datalogger® unit .
Other Features:
Pipe lift located on front and back
Thrust bearing clamp knobs
Three mode manifold block
High flotation tires
Heater with butt fusion heater plates
Quick change inserts for various pipe sizes
Positive locking wheel brake
TX02312-04-24-17
Specifications
65.5"
1664mm
49.5"
1257mm
38"
965mm
To Next Page
Loading...
