Overview
Chassis
The carriage assembly is mounted on a four wheel chassis for
mobility and movement along the pipe line.
There is a pinned wheel lock on the left rear wheel to prevent
rolling.
The chassis is not designed for over-road towing.
Towing at speeds greater than five miles per hour
can result in machine damage as well as injury.
Always transport the machine by flatbed truck or
similar means, and make sure that unit is properly
secured.
The tongue on the tow bar has a ring to slip over a ball hitch so
that the machine may be conveniently maneuvered at the job site.
The tow bar acts as front pipe lift when raised.
The chassis is not designed for over-road towing.
TX02129-07-08-03
PH02969-3-29-05
Hydraulic Fluid Reservoir
The reservoir is incorporated in the chassis. The fluid level should
remain visible in the sight gauge in the side of the filler spout.
Never allow dirt or other foreign matter to enter the open tank.
Refer to the "Hydraulic Fluids" section of this manual for hydraulic
fluid recommendations.
TX00353-04-28-14
PH02483-07-08-03
PH02484-07-08-03
2 - 3
To Next Page
Loading...
