Begin Facing
Move the carriage to the right.
Turn on the facer.
Assure the selector valve handle is up in the facing position.
Move the carriage control valve to the left.
If the facer stalls, adjust the facing pressure so the facer continues to
cut.
Let the carriage bottom out on facer stops.
Allow the facer to run for several revolutions to ensure that there
are no chips hanging on the end of the pipe.
Turn facer off.
TX04008-4-12-10
PH04125-4-5-10
Butt Fusion Procedure
3 - 7
PH04107-3-29-10
Clamp the Pipe
Tighten the clamp knobs on the outside jaws to prevent pipe from
slipping. Hand tighten the inside clamp knobs to allow for HI/LO
adjustment.
The clamp knobs are equipped with a ball thrust bearing, which
permit the operator to develop high clamp forces with minimal
effort.
NOTICE: When clamping, do not over-tighten the clamp knobs
because machine damage can result. Check to see if there is
space between the upper and lower jaws. If the two jaws are
touching, do not continue to tighten.
TX04007-4-12-10
PH04135-4-12-10
To Next Page
Loading...