Special Operations - In Ditch
4 - 4
Make Fusion Joint
Refer to the "Butt Fusion Procedure" for operating instructions.
After facing operation, remove the facer from ditch.
TX00450-9-16-94
PH00363-9-12-94
Remove Carriage Assembly from Ditch
Loosen clamp knobs and remove top jaws if needed.
Rotate carriage assembly from under the pipe.
Use one of the recommended lifting methods from "Lower the
Carriage into Ditch" section of this manual to lift the carriage from
the ditch.
Lift carriage assembly from ditch.
TX04020-4-12-10
Attach Carriage to Skid
Install carriage assembly to the skid. Refer to the "Remove Carriage
from Base" section of this manual and follow instructions in reverse
to attach carriage to skid.
Replace top jaws if removed.
TX04021-4-12-10
PH04121-4-5-10
PH04124-4-5-10PH04123-4-5-10
To Next Page
Loading...