McHale V Series Baler
103
9.15.5 Brake maintenance
Drain condensation water from the air reservoir (air brake only)
Actuate the manual drain valve as necessary by pulling the ring, each day before
operating for a few seconds or until the water droplets disappear.
Ensure that the hand brake is engaged before carrying out this procedure.
Check the brake hoses regularly
Check the condition of the brake hoses monthly for any signs of cracking or abrasion.
Ensure there is no contact from surrounding objects that could cause damage or wear
over time.
Check the hand brake cables
Check the hand brake cables monthly for signs of stretch, wear or deterioration.
9.16 Adjusting pick-up float springs
The spring retained collars which are used to adjust the pick-up float springs are
located on either side, underneath the chopper unit. To adjust, follow the procedure
below:
1. Using the tractor spool handle, hydraulically raise the pick-up, in order to
release float spring pressure. Close the tap on the hydraulic line to prevent the
pick-up from moving.
2. Ensure that the tractor engine has been shut down, the key removed and the
brakes applied before carrying out the following procedure.
To Next Page
Loading...
