McHale V Series Baler
119
12.1.7 Issue with bale quality/density
12.1.8 Net not feeding during an automatic cycle
12.1.9 Greaser not working (if fitted)
Symptom Reason Solution
Issues with bale quality/
density
When closing the door the
spool is moving into the
float position, as a result
the chamber is not being
pressurised
Attach the door functions
to the tractor spool without
a float position
Issues with bale quality/
density
Density set too low for the
crop conditions
Increase the density
Issues with bale quality/
density
Ground speed too high Reducing ground speed
will allow the machine to
pack the bale better
Machine making bales
with soft edges/corners
The centre of the bale is
being overfilled
(See ‘Swath preparation’)
Net not feeding during an
automatic cycle
Control box is in MAN
mode
Switch the control box to
AUTO mode
Net not feeding during an
automatic cycle
Net knife has tripped Activating the spool valve
in the door close direction
automatically resets the
net knife
Net not feeding during an
automatic cycle
Bad power supply to
control box
Check power source
Net not feeding during an
automatic cycle
Faulty net knife sensor Contact McHale dealer
Net not feeding during an
automatic cycle
Faulty clutch / belts loose
or worn
Contact McHale dealer /
tighten or replace belts
Symptom Reason Solution
Machine not using grease Air locked Bleed the cartridge by
unscrewing it 2-3 turns
(See ‘Replacing refill
grease cartridge and
releasing airlock:’)
Machine not using grease Blockage in the system Contact McHale dealer
To Next Page
Loading...
