PRE-DELIVERY INSPECTION (PDI)
Dealer:..............................................................
Model:
F5 & V Series balers
Full address:...................................................... Serial No:..........................................................
.......................................................................... Date delivered:.................................................
Fitter:................................................................. Date inspected:.................................................
Customer:........................................................
Full address:..................................................... Tel:.....................................................................
.......................................................................... Mobile:...............................................................
.......................................................................... E-mail:...............................................................
ENSURE THAT THE TRACTOR IS OF THE CORRECT SPECIFICATION FOR THIS MACHINE.
REFER TO THE OPERATOR INSTRUCTION MANUAL BEFORE MAKING ANY ADJUSTMENTS!
This machine must be registered on www.mchale.net by the dealer in order to qualify for warranty!
1. Check that all accessories are with the
owner/operator. Check Operators
Instruction Manual and Parts Lists.
9. Ensure that the control-unit is on the
correct program to suit the machine
specification.
2. Ensure machine is re-assembled
correctly. (Refer to all assembly
instructions supplied)
10. Check both Manual and Auto functions
on the control box. Run machine
through automatic cycle on the control
unit.
3. Ensure that the wheels are correctly
fitted (i.e. valve to the outside). Torque
wheel nuts correctly.
11. Check for smooth operation of the
pick-up reel when machine is run at 540/
1,000 rpm.
4. Check for correct tyre type, tread and
pressure.
12. Check that all electrics and lights
function correctly.
5. Hitch machine to tractor, then connect
PTO shaft. Adjust PTO length if
required.
13. Ensure netter operation and netter-knife
are operating correctly.
6. When hitched to tractor check that the
machine is level with the ground. Adjust
drawbar if necessary. Attach 7-pin plug
for lighting system.
14. The operator must be fully aware of all
hazards, controls (electric & hydraulic),
all functions & safety devices of both
the machine and the tractor.
7. Connect hydraulic hosing to tractor and
ensure proper hydraulic setup.
Note: Ensure free-flow return to tank is
fitted where required.
15. Ensure that the owner/operator reads
the operator instruction manual and
understands fully all safety & operating
aspects of the machine, as described.
8. Ensure control-unit power supply is
12 V direct from battery otherwise the
machine may malfunction.
16. Instruct operator on machine
maintenance i.e. check chain tensions,
adjustments, tyre pressure and wheel
nuts, also areas to be greased daily and
oiler/greaser functions.
I am satisfied that the above checks have been carried out, and that the machine is complete with all
accessories and manuals.
Signed:................................................................................... (Dealer) Date:..............................
Signed:................................................................................... (Owner) Date:..............................
A signed copy of this form is to be retained by both the dealer and the customer.
To Next Page
Loading...
