McHale V Series Baler
30
Never perform any adjustments or reach into the netter
unless the PTO has been disengaged and the tractor
has been shut down and the key has been removed. It
is also recommended that the tension be released
from the netter knife to avoid it being tripped
accidentally.
(CST00142)
Check tyre pressure and wheel nuts daily
(CST00259)
Float decal. Indicating that during operation of the
baler, the control lever of the spool operating the
pick-up reel should be in the float position.
(CST00609)
Maximum oil pressure.
This machine must not be connected to hydraulic
systems with pressure higher than 210 bar
(CST00657)
The PTO wide angle joint must never exceed
80 degrees, both when stationary or during operation.
Permanent damage may result otherwise.
(CST00658)
Wheel direction
(CST00711)
To Next Page
Loading...
