To Next Page

To Previous Page

Page 143 Speed Level Series - Service & Parts Manual

January 2019Section 9 - Troubleshooting - 3084ES Models

Function Active Messages

The following HELP messages indicate that there is no problem with the GP400 but that a function is

active – the vehicle should be moving as requested by the operator.

DRIVING! _____________________________________________ (no flash code)

LIFTING! ______________________________________________ (no flash code)

LOWERING! ___________________________________________ (no flash code)

STEERING! ___________________________________________ (no flash code)

EXTENDING OUTRIGGERS! ______________________________ (no flash code)

RETRACTING OUTRIGGERS! ____________________________ (no flash code)

Calibration Messages

The following are “calibration” HELP messages – until the machine is properly calibrated for height

and/or pressure (as required), many functions will not be available.

NOT CALIBRATED ______________________________________ Flash Code: 1/1

FUNCTIONS LOCKED - NOT CALIBRATED __________________ Flash Code: 1/1

The height and/or pressure sensors have not been calibrated and are required because of the

setup of the GP400.

Calibration procedures are accessible from the SETUPS/HEIGHT SETUPS and SETUPS/LOAD

SETUPS menus.

FAULT: CUSTOMER _____________________________________ Flash Code: 1/1

The system must be configured to the customer requirements – with the EZ-Cal in SETUPS/

CHANGE DEFAULTS menu, scroll to the correct machine from this menu, the press Right Arrow

to select the appropriate model.

Note:Selecting the incorrect customer or model will cause the machine to operate incorrectly or go

into fault mode.

•

Mec Speed Level Series User Manual

Questions and Answers: