15
Click on "OK”.
Until you choose a new password for the administrator account, this message will continue
to appear.
• If this is not your first use, and you have already created at least one user account (caution,
do not confuse a "user account" and the "name of the robot”
5
).
Write down the username and password for one of your user accounts.
5) When you have entered the correct username and password, the "authentication" window will
close automatically.
6) The console will connect to Spykee:
> Spykee’s webcam image will appear on the console’s screen and the connection icon will
turn green.
> It will make a “gling gling gling” sound and its lights will flash slowly.
> This means that you are now connected!
If Spykee does not connect and/or the image is not displayed:
> Check that your computer is correctly connected to your robot’s WiFi network
6
then initiate
the console again.
> If it still doesn’t work, please refer to the "Frequently Asked Questions" at the end of this manual.
7) Now please go to the following chapter to configure your console and/or robot. It is very
important to do so at the first use; do not omit these steps.
6.4. Configuring your console and robot
Please note that to configure the robot, you must be connected to your Spykee in local mode
with the administrator name and password (if you have not already changed it, the username is
"admin" and the password is also "admin").
6.4.1. Console configuration / General tab
• Go to the Preferences menu to display your robot's configuration window. To do this, click on
the menu bar, select Spykee Console, then Preferences in the pull-down menu. *
You can also use the following keyboard shortcut:
4
See Section 6.4.3 of this chapter "Robot configuration / My Spykee tab"
5
For more information see Section 6.4.3 of this chapter “Robot configuration / My Spykee tab"
6
See Section 6.2 of this chapter.
To Next Page
Loading...
Need help?
General
