CashFlow
952X / 952Xe / 9510 User Guide
MEI., 2005 Page 22 Rev: G2
COIN ROUTING CF952X/CF952Xe
This following diagrams show the coin exit paths for a routed coin. Coin Routing can be set
using the configuration switches found on the front of the CF952X/CF952Xe. A primary,
secondary, or tertiary route may be selected. Please refer to the configuration section
relating to switches 7 and 8 combined.
SW7 on = Primary, SW8 on = Secondary, SW7 and SW8 on = Tertiary. Illustrated here are
the switch setting for selecting Tertiary.
Switches 7, 8 or both 7 & 8 are Used for Route Teach. Depending on the route inhibit
status, the acceptor has 4 routing priorities. These are referred to as:- Default, Primary,
Secondary and Tertiary. Only the Primary, Secondary and Tertiary can be taught using
switches 7 and 8 or both 7 and 8.
Notes:
1. If the primary route gets full, coins for that route will automatically go to the secondary
route.
2. All CF952X/CF952Xe Validators leave the factory programmed with “all coins to the
default route”.
CF9524/CF9524e 4-WAY SEPARATOR
Default Route = A
CF9528/CF9528e 8-WAY SEPARATOR
Default Route = 8
ON
OFF
12345678
= Switch OFF = Switch ON =Don’t Care
KEY
Default Route
Coin Reject
1
2
3
4
6
578
Coin Tube Exits
Cash Box Exits
Default Route
D
A
B
C
1
2
3
4
5
6
7
8
To Next Page
Loading...
Need help?
General
