CashFlow
952X / 952Xe / 9510 User Guide
MEI., 2005 Page 33 Rev: G2
SW7 and SW8 – Route Teach
(Common to the CF952X and CF952Xe)
The acceptor has 4 or 8 coin routes depending on the route inhibit status, the first routes can
be taught using switches 7 and 8.
The order of priority is primary, secondary then tertiary. For example, if the primary route is
full, the secondary route is then selected.
On a CF9524/CF9524e 4-way separator, route 'a' is the default route and on
CF9528/CF9528e 8-way separator route '8'. All CF952x/C952Xe acceptors leave the factory
programmed with "all coins to the default route".
To program a route, the reject lever needs to be pressed a specified number of
times (see Table below). When in this mode the Green light will flash (cycle)
the current route, followed by a single Red flash. Press the reject Lever the
number of times for the coin route required and then Insert the Coin or Coins
that requires routing.
Examples:
The acceptor starts at the normal default route for the separator fitted. Press Reject Lever to
cycle down through the routes, i.e. one press per position.
For example, by pressing Reject Lever once will select route ‘b’ on a CF9524 or route 7 on a
CF9528. This will be visually indicated by the green LED flashing on and off seven times
followed by the red LED flashing on and off once.
Pressing Reject Lever twice will select route ‘d’ on a CF9524, or route 6 on a CF9528. This
will be visually indicated by the green LED flashing on and off six times followed by the red
LED flashing on and off once.
Pressing Reject Lever three times will select route ‘c’ on a CF9524, or route 5 on a CF9528.
This will be visually indicated by the green LED flashing on and off five times followed by the
red LED flashing on and off once and so on.
This pattern will be repeated until either the Reject Lever is pressed again, when the new
route pattern will be displayed.. If a coin is inserted then the green LED will flash if the coin is
recognised, or the red LED will flash if the coin is not recognised.
No of reject lever presses 0 1 2 3 4 5 6 7
No of green flash codes 8 7 6 5 4 3 2 1
Route selected (CF9524/CF9524e - 4 way) a b d c B A C D
Route selected (CF9528/CF9528e - 8 way) 8 7 6 5 4 3 2 1
Route Inhibit Connector Pin No. 8 7 6 5 4 3 2 1
ON
OFF
12345678
ON
OFF
12345678
To Next Page
Loading...
Need help?
General
