CashFlow
952X / 952Xe / 9510 User Guide
MEI., 2005 Page 42 Rev: G2
MAINTENANCE
Note: The practical maintenance that can be carried out is limited to cleaning the
areas of the validator that the coins travel through, and the replacement of the coin
entry liner if it becomes worn. All other servicing should be carried out at your
approved service centre.
The cleaning should be carried out on a regular basis of at least once a month.
The shaded areas shown below are those to be cared for.
The coin entry liner is accessed by unscrewing the coin entry moulding at the top of the
validator. The coin entry liner can then be eased off with the aid of a fine screwdriver, and a
replacement slid into place.
• Cleaning and maintenance must only be carried out by suitably trained personnel.
• Cleaning must only be carried out after power has been removed from the product.
• Never use a cleaner containing solvents, scrapers or abrasive materials.
• Never apply water or cleansers directly onto the product. Always apply them to a
clean cloth first, and not too liberally, so that the cloth used is only moist.
Clean Shaded Area
Coin Entry Liner
Coin Entry Moulding
To Next Page
Loading...
Need help?
General
