193 of 289
b. Remove the PCB cover.
•
CAUTION!! Be careful not to drop metallic hardware or tools onto the Main PCB while it is
exposed. Doing so can result in severe damage to the electronics that might be expensive to
repair.
18. Run the color change harness from the back side into the right access hole to the main PCB and
connect it at the color change connector socket located at “CC Motor” on the main PCB.
19. Install the covers in the reverse order that you removed them.
20. Turn the machine ON.
21. Do a short functional test and execute several color changes to ensure that the harness is properly
connected and works properly.
To Next Page
