Into Folders by Date
Creates a folder within the “import” folder to store the imported files from
the connected USB drive. The folder name will contain the import date.
Imported files may contain duplicates in the N10/N100 if the same files are
on the USB drive.
USB-DAC
Configure settings to convert DSD files using a USB-DAC.
Controller Mode Configures the mode to stream music using controller apps.
DSD Playback Mode
Configures the playback mode if playing DSD files on the N10/N100 using a
USB-DAC.
If playing DSD files without converting them, select “Standard”. This mode
will select the playback mode between Markerless DSD playback or DoP
(DSD over PCM) playback for the DSD files automatically. Use this mode
normally. If you prefer the DoP playback, select “DSD over PCM Priority
mode”. If the connected USB-DAC only supports PCM, select “PCM mode”.
Precision Start Latency
Configures a gap time that precedes a playlist track. This also solves an issue
that occurs with specific USB-DAC devices.
USB-CD Drive
Configure settings to import music files from a music CD using an optical drive.
CD-DA Import File Format
Selects import file formats from either “FLAC” or “WAV”. If you select “FLAC”,
configure the compression level used when importing music files as well.
Available compression levels are below.
No Compression: The music files will not be compressed during importing.
Low Compression: Compression time is less than standard compression. The
resulting file quality corresponds to FLAC 0.
Standard Compression: Compression time is not as long and the size
remains average. This is the same as common FLAC file format. The resulting
file quality corresponds to FLAC 5.
High Compression: Compression time is longer but the resulting file size is
smaller. The resulting file quality corresponds to FLAC 8.
Maximum Read Count
Configures the number of times a CD will be read when inserted into the
N10/N100.
Advanced Drive Optimization
Configures the read sample offset correction values between “-2000” to
“+2000”. This value will vary depending on what type of CD drive you use. It
is configured to “±0” by default. This doesn’t need to be changed normally.
Date and Time
Configure the time settings of the N10/N100.
Auto Configures the time settings acquired from the NTP server via the Internet.
Manual Configures the time settings manually.
Time Zone
Configure the time zone for date and time settings.
To Next Page
Loading...
