4-9
MELTER OPERATION MA-5052-ENG MACRO SERIES MELTER MANUAL
On the left display, you will see the time with a dot, indicating that this
is the value that may be modified, while the minutes appear on the
second display.
3. Use the up-down arrow to select the desired value.
4. Press the button with the clock symbol once again.
Now the dot will appear on the right display.
5. Use the up-down arrow to select the desired value.
6. Press the button with the clock symbol once again.
A number appears, indicating the day of the week (1- Monday / 7-
Sunday).
7. Use the up-down arrow to select the desired value.
8. Press the button with the clock symbol once again.
The ‘0’ program appears once again.
9. Pressing either the left or the right arrow button will exit this program
and return to the tank temperature display.
Programming equipment activation/deactivation
You may program an activation and a deactivation time for every day of the
week, from Monday (1) to Sunday (7).
Time is expressed in 15 minute increments, so we cycle from 10.0 (10 hours
and 0 minutes) to 10.1 (10 hours and 15 minutes) to 10.2 (10 hours and 30
minutes) to 10.3 (10 hours and 45 minutes).
1. Press the button with the clock symbol.
A ‘0’ will appear on the display, indicating the program for current day
and hour information.
2. Use the up-down arrow to select the value for the desired day of the
week, from Monday (1) to Sunday (7).
3. Press the button with the clock symbol once again.
Two times will appear, one in each display. The display on the left shows
the start time, while the display on the right shows the finish time.
02 02 .08 .08
.02 .02 08 08
2 2
0 0
2 2
0 0
160160160160
To Next Page
Loading...
Need help?
General