FOCKE MELER GLUING SOLUTIONS
4-10
MELTER OPERATION
4. The blinking dot next to the start time indicates that this is the value
that may be modified. Use the up-down arrow to select the desired
value.
5. Press the button with the clock symbol once again.
The dot changes to the finish time.
6. Use the up-down arrow to select the desired value.
7. Press the button with the clock symbol once again.
The selected program will appear once again. Use the up-down arrow
to select other programs.
8. Pressing either the left or the right arrow button will exit this program
and return to the tank temperature display.
The green LED next to the ‘ON/OFF’ button will remain blinking as long as
there is an equipment disconnection time programmed for the current day.
Disabling the equipment activation/deactivation program
It is possible to disable the equipment activation/deactivation programming
without canceling the daily programming. This way the programmed data is
saved, but the programming will have no effect on the equipment.
1. Press the button with the clock symbol.
A ‘0’ will appear on the display, indicating the program for current day
and hour information.
2. Use the up-down arrow to go past the selection for the last day of the
week (7).
The message ‘ON/OFF’ will appear on the display, depending on the
current status.
3. Press the button with the clock symbol once again.
The status will alternate each time you press the button.
4. Pressing either the left or the right arrow button will exit this program
and return to the tank temperature display.
160160160160
160160160160
2 2
19.319.3
07.207.2
19.319.3
07.207.2
0 0
offoff
To Next Page
Loading...