FOCKE MELER GLUING SOLUTIONS
4-12
MELTER OPERATION
8. Press the button with the clock symbol once again.
The selected program appears once again. You may use the up-down
arrow to select other programs.
9. Pressing either the left or the right arrow button will exit this program
and return to the tank temperature display.
The green LED next to the ‘standby’ button will remain blinking as long as
there is an equipment standby function activation time programmed for the
current day.
Disabling the equipment standby function programming
It is possible to disable the equipment standby function programming without
canceling the daily programming. This way the programmed data is saved,
but the programming will have no effect on the equipment.
1. Press the button with the clock symbol.
A ‘0’ will appear on the display, indicating the program for current day
and hour information.
2. Press the standby function button.
A ‘1’ will appear, indicating the first day in the standby function
programming.
3. Use the up-down arrow to go past the selection for the last day of the
week (7).
The message ‘ON/OFF’ will appear on the display, depending on the
current status.
4. Press the button with the clock symbol once again.
The status will alternate each time you press the button.
5. Pressing either the left or the right arrow button will exit this program
and return to the tank temperature display.
Special function buttons
The simplicity of programming Macro system series melters reduces the use
of the special function buttons to only the standby function.
This manual function allows you to alternate between the operational mode
160160160160
0 0
1 1
offoff
160160160160
To Next Page
Loading...
Need help?
General