PASSWORD prompt simply enter the current mas-
ter password. Then at the CHOOSE A NEW PASS-
WORD prompt enter the digit or digits desired,
then press [=].
The requirement for a zero password can be turned
off so that zero adjustments can be made more
easily. To disable the zero password requirement
merely exit the CHANGE PASSWORD function by
pressing [=] without entering a zero password.
Both the zero and master passwords were set at the
factory to 123456. Again, since passwords are
seldom used, they are easily forgotten. Please keep
a written record of the latest changes as they are
entered. Contact Mensor Corporation if the master
password is lost.
LOCAL OPERATION PCS 400
3-16 www.mensor.com
To Next Page
Loading...