To Next PageTo Next Page
Need help?Do you have a question about the mensor PCS 400 and is the answer not in the manual?
General| Type | Pressure Controller/Calibrator |
|---|---|
| Power Supply | 100-240 VAC, 50/60 Hz |
| Resolution | 0.001 psi |
| Interface | RS232, IEEE-488 |
| Operating Temperature | 15 to 35 °C (59 to 95 °F) |
| Output | Analog, Digital |
| Accuracy | ±0.01% of full scale |
Lists and briefly describes the various functions available on the PCS 400.
Guides the user through the initial power-up sequence and basic checks of the PCS 400.
Details the type of pressure ports and required fittings for connecting to the PCS 400.
Step-by-step guide for powering on the instrument and its initialization process.
Procedures for performing system checkout, including control pressure and leak tests.
Explains the role of transducers, including primary and active transducer identification.
Guides on connecting supply pressure and setting up for control mode operation.
Details the primary functional modes (STANDBY, MEASURE, CONTROL, VENT) and navigation.
Explains how to operate the instrument in MEASURE mode and select appropriate transducers.
Explains the CALIBRATION function for transducers and A/D electronics.
Explains the NORM and RATE control modes for outputting regulated pressure.
Details the TEST function for performing built-in diagnostics on electrical and pneumatic functions.
Provides guidance on diagnosing and resolving common instrument issues.
