INTRODUCTION
DID YOU GET EVERYTHING?
In addition to this manual you should have:
· PCS 400
· Power cord
· Four 1/8 inch NPT fitting adapters
· Any accessories ordered
· An envelope containing a Calibration
Certificate
INITIAL INSPECTION
Your new Mensor instrument was thoroughly
tested and inspected at the factory, and it was free
of dings, dents and scratches when it was packaged
for shipment. Please examine it now for signs of
shipping damage. Report any apparent damage to
the carrier immediately.
MEET YOUR MODEL PCS 400
The Model PCS 400 Pressure Calibration System is
a self-contained, computerized, high accuracy
pressure management system integrated into a
single, compact unit. The system is comprised of a
front panel assembly, a rear panel, an electrical
module, a pneumatic module, and a chassis to tie
it all together. The system functions either as a
bench-top or a rack mounted instrument. It can
operate in local mode to accept front panel input,
or in remote mode to communicate with external
devices. A brief description of the major elements
of the system follows.
Front Panel
The front panel (figure 1.1) includes a forty char-
acter per line, two line display, a four by four
membrane keypad, and a transparent window for
the pressure range label. The keypad includes
fifteen dual-function keys, plus a sixteenth key,
labeled 2nd, which toggles the function of the other
fifteen. All sixteen keys provide both tactile and
audible feedback.
Keypad
Display
Pressure
Range
0-600 PS
I
A
2nd
F1
F2 F3
1
0
=
5
_
3
.
7
2
9
6
4
+
8CE
METRIC ENG GPIB SERIAL
CAL TEST LIMITS HELP
STBY CONT VENTMEAS
UNITS COMM
PRESSURE CALIBRATION SYSTE M
Figure 1.1 - Front Panel
PCS 400 INTRODUCTION
www.mensor.com 1-1
To Next Page
Loading...