Mercury Avator 7.5e User Manual

This product must be secured to the transom with the required mounting
hardware. If the outboard strikes an underwater object, the required mounting
hardware prevents the outboard from propelling off the transom. A decal on the
swivel bracket reminds the installer of the potential hazard.
75272
IMPORTANT:Do not use the transom assembly of the outboard to guide
the drill. Use the included template to mark the holes and if a drill fixture is
required, use the drill fixture specific to Avator 7.5e.
1. Place the template or drill fixture on the boat's transom, paying special
attention to the centerline guide and the folded top of the template.
2. With the transom template, part number 8M0182092, mark where the
lower 9 mm (3/8 in.) holes in the boat's transom will be drilled.
INSTALLATION
 38 eng

Mercury Avator 7.5e Specifications

General

Power Source	Electric
Control	Tiller
Mounting	Transom
Operating Voltage	48V
Power	750W
Engine Type	Electric motor
Run Time	Up to 1 hour at full throttle
Propeller	3-blade
Warranty	2 years
Shaft Length	Short