3. Use a 9 mm (3/8 in.) drill bit to drill the two lower holes through the
transom.
IMPORTANT:Do not apply marine sealer to the threads of the bolts.
4. Apply marine sealer (obtain locally) to the shanks of the bolts.
5.
Remove the battery from the outboard. Refer to Battery Removal.
6. Tiller models only ‑ use the quick release to separate the transom clamp
bracket assembly from the swivel bracket. Refer to Quick Release ‑ Tiller
Models Only
7. Tiller models only ‑ Install the transom bracket on the boat with the
included mounting fasteners.
8. Remote control models only ‑ Install the transom bracket and the
outboard on the boat with the included mounting fasteners.
9. Tighten the mounting fasteners to the specified torque.
INSTALLATION
eng 39
To Next Page
Loading...
