IMPORTANT:Before trimming the outboard into the shallow water drive
position, power off the outboard.
While in the shallow water drive position, do not operate the outboard
in reverse. Operate the outboard at slow speed, and keep the propeller
submerged.
If beaching the boat on the shore, leave the reverse lock lever in the free or
unlocked position. Do not operate the boat above 3.2 kph (2 mph) while the
reverse lock is in the unlocked position.
Trim the outboard to the desired position for shallow water operation. Refer to
Basic Trimming Operation.
OPERATING ANGLE ADJUSTMENT
The transom brackets have five trim positions for adjusting the vertical
operating angle of the outboard.
Adjust the vertical operating angle of the outboard so that the outboard runs
perpendicular to the water when the boat is at full speed.
FEATURES AND CONTROLS
eng 71
To Next Page
Loading...
Need help?
General
