300Mbps High Power Wireless N Router
5.1.2 LAN Settings
Go to Network→LAN Settings, then you can configure the IP parameters of the LAN on the
screen as below.
• MAC Address - The physical address of the router, as seen from the LAN. The value can't
be changed.
• LAN IP Settings - Select Auto or Manual. In Auto mode, the router will automatically detect
the LAN-WAN IP address confliction.
• IP Address - Enter the IP address of your router.
• Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
5.1.3 IPv6
Go to Network→IPv6, you can configure IPv6 settings of your router.
1)
If you change the LAN IP address, you must use the new IP address to log in to the router.
2)
If the new LAN IP address you set is not in the same subnet with the previous one, the IP
Address pool in the DHCP server will be configured automatically, but
and DMZ Host will not take effect until they are re-configured.
- 22 -